Questions & Answers for: Mitsubishi ground strap

Ad

Question about Mitsubishi

1 Answer

...put in the car as well as the wiring harness that runs it all. then you can lower the tank to the ground and from there you have to remover the circle ring to gain access to the pump by tapping it ...

Ad

Question about WD-52525 52" Rear Projection HDTV

1 Answer

ws55513 ticking noise and no picture after replaced caps Hello!I have the blinking light of death and I have replaced the capacitors and I still have the blinking light. The caps were bulged out so ...

Ad

alternator charging, battery & all connections are clean in good shape & tight, especially ground cables or straps

Question about 2004 Galant

1 Answer

...strap that runs from the firewall to engine, insure its clean with good connections. Then check the connections at the alternator, be certain that these too are clean and tight. After which reconnect ...

Question about 2002 Lancer

1 Answer

...good condition and properly gapped. Check all ground connections, body to motor ground strap, battery to motor and body ground. Also change fuel filter if it has not been changed within 50,000

Question about 2002 Lancer

1 Answer

...off while driving and come back again on and off. thanks in advance. it sounds like you have a bad connector or engine ground strap, maybe have the battery tested for a shorted cell if not the ...

...would say no to reg or alt ,when you apply brakes there is dimming and that sounds like a negitive grounding problem not at battery,the dimming is caused from a back feed of ground possible.there

Question about 2000 Lancer

1 Answer

wipers will not turn off Wipers won't stop running. I have changed the motor and switch wiper stalk, but it still won't stop. it happen a few days ago after I refill petrol. Thanks Odd effects like ...

...ground cable attached to the engine block. But I had replaced the engine at one time and failed to replace the bonding strap from the engine to the firewall. As a result, the engine, being on rubber ...

...strap slides onto your wrist and the other end connects to a metal ground point on the chassis. This prevents static discharge from your body from ruining delicate circuit logic on the board. Be sure ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...