Questions & Answers for: hot melt glue gun Food Mixers

Ad

Question about De Luxe Hand Mixer

2 Answers

hot water for 10-20 minutes, then try again. This should free trapped food from the shaft We use the Bamix daily to froth milk for coffee but find that over time, milk accumulates inside the shaft and

Ad

Question about M880 MultiMix Hand Mixer

3 Answers

sees a lot of vibration and shock, this heat sink should be tie strapped or have hot melt glue to prevent movement. Gary What you said was true but it didn't solve the problem. Switch must be bad also

Ad

Question about KP2671 Professional 6 Series Stand Mixer

1 Answer

in the Kitchen Aid factory and they used a thick grease and no oil in the mixer. Does your unit get hot? Maybe its melting the grease (dark brown).

Question about KSM5PS Heavy Duty Stand Mixer

1 Answer

BMW door seal? How to replace a door seal on a 2002 BMW 325I, left front? make sure you have the new one on hand also the glue you can pick up the glue at a local autoparts store. Now lay the new door

Question about KSM5PS Heavy Duty Stand Mixer

1 Answer

...glue. How to fix? Get a squirt gun. yep fill it with hot water and squirt it up in the hook and loop portion of the attachment shaft let it sit for 5-10 mins and repeat a couple times. the ...

...hot to melt the "Gunk" that is acting like glue, I have actually had to use a torch once or twice, you can polish the stainless steel up again but you have to keep it away from the powder coated ...

...I puchased at your store in Richmond BC. It was purchased in May,2013 and worked well during the hot months. As fall approached it has never been used and has remained in the upright position. ...

Question about DD-60 Stand Mixer

1 Answer

...where the beater fits into. Fill a mixing bowl or a jug deep enough to fit over beater with very hot or boiling water. Immerse the stuck beater in the water up to where it connects in to the mixer ...

...and is attached by some adhesive. Can I simply place the two pieces of the magnet back on the shaft and use hot glue, or other adhesive, to hold it in place? I would try a cyanoacrylate

Question about 800 Watts CPM700 Commercial Stand Mixer

1 Answer

...part that spins the attachments That would normally signify that that particular part is getting hot. Try and get inside that head and clean the old grease off and replace with High Melting Point ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...