Questions & Answers for: pinch bolts

Ad

Question about 1973 TRX 75 Hurricane

1 Answer

Help where are the pinch bolt located on the hurricane x75? a pinch bolt will fasten more the front suspension too the lower yoke they are as they say a pinch type fastening that tighten their grip on

Ad

...pinch bolts = 8NM Brake caliper to fork bolts = 30NM Rear wheel bolts M10x53x1,25 = 60NM Brake caliper to fork torque needed if changing to SM wheels. Method. Torque greased axle bolt to 50NM, then ...

Ad

...pinch bolts to secure the axle for tightening the nut. tighten the nut to 29.5 ftlbs. and loosen the left pinch bolts. now tighten the right pinch bolts and compress the front suspension while the ...

Question about 2005 XL 1200 C Sportster Custom

1 Answer

...bolts = 12-15 ft. lbs. Front Fork Upper bracket pinch bolts = 30-35 ft. lbs. Lower bracket pinch bolts = 30-35 ft. lbs. Fork stem pinch bolt = 30-35 ft. lbs. Front fender fasteners = 9-13 ft.

Question about 2001 V92 Sport Cruiser

1 Answer

...pinch bolts as well as fluid/air gap level or fork capacity for a '00 v92sc You need 525cc's per tube, step up to a 15w as well. The factory says 10w. It doesnt provide enough damping. what do you ...

Question about 2001 V92 Sport Cruiser

1 Answer

pinch bolts tight in that end of the axle. So, in order- 1-remove axle nut. 2-remove 2 bolts holding the brake caliper to the fork and tie it back out of the way.3 loosen the pinch bolts at the bottom

Question about 2002 CR 125 R

2 Answers

...pinch bolts on each fork leg. If you don't have the big Allen key, do this- Remove the axle nut on the brake side. Remove the 2 bolts that hold the brake caliper on and swing it out of the ...

Question about 2002 CR 125 R

1 Answer

raising the seat Most common bicycles have a pinch bolt at the bottom of the rod that holds the seat. This bolt goes through two holes in a clamp affixed to the frame of the bicycle. If you loosen ...

Question about 2002 CR 125 R

1 Answer

...lever Kawasaki KX 125 motorcross-cant get the lever to come off, just hangs loose Does it have a pinch bolt? If so undo and remove the pinch bolt, if the lever doesn't slide off you will need to ...

...Pinch Bolt does not want to come out. Tried using heat but it does not come out. I broke the head off of one already. break the other one off and buy new bolts. Make sure you get the correct ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6103 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

richard libby

Level 2 Expert

209 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...