Questions & Answers for: thermal cutout

Ad

Question about Washing Machines

1 Answer

thermal cutout. jumpered it and got heat. the jumper wire (smaller gauge) immediately got warm Where might my real problem be. ohms on heater element were 8 The problem is with the Thermal Cutout. The

Ad

Question about Ovens

1 Answer

power to oven lights but not to cook top or oven. checked pigtail and breaker, both ok. Thermal cutout? Yeah sounds like a Thermal cutout to me ... do you have 120V on both sides??

Ad

thermal cutout required-no heater element working but heater element is fine when cutout is temporarily bridged-need part nr of cutout Usually, there are 2 or 3 thremal cutouts in these machines (Side

Question about LER5636P Electric Dryer

2 Answers

thermal cutout read open on the ohm-meter. I replaced the thermal cutout and the element heated for a few minutes then shutdown. I rechecked the thermal cutout and it now reads open again. Do you have

thermal cutout, What causes this? Condenser fan motor but compressor will not start. Relay does not engage. if it's a thermal cutout that's mounted on the circuit board you may have to replace

...thermal cutout pops on tank two after it shuts off. It boils then shuts off. It also turns off when taking a shower, producing cold water. I checked the ohm readings on the thermal cutout and the ...

Question about 2003 FLHTCUI Electra Glide Ultra Classic

1 Answer

...shuts down when hot? After it cools down for a few minutes it starts back up. Thermal safety cutout is shutting down ignition, if you don't feel the engine is that hot replace thermal cutout and ...

Question about 2003 FLHTCUI Electra Glide Ultra Classic

1 Answer

Thermal overload cutout tripped or is defective and needs replaced. Look for a red reset button near the heater element on the thermal overload. If no reset button, replace the thermal overload cutout

Question about 2003 FLHTCUI Electra Glide Ultra Classic

1 Answer

thermal cutout (thermal fuse) must be replaced. However, when any "fuse" is bad, it indicates a problem with the normal operation of the machine and the fuse has protected the machine by disconnecting

...Thermal cutout in High Stage, 71-Thermal cutout in Low Stage, and 82-Thermal Lockout in High Stage. It's a Carrier Infinity model 25HNA9. Any ideas? You probably need to get a service tech out. Here ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

Brad Brown

Level 3 Expert

18121 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...