Andis Irons - Page 4 - Recent Questions, Troubleshooting & Support


1. Check the control at the top near the front is set to the steam position. Sometimes this is a number 1 or 2.
2. Steam only comes out when the iron is in the ironing position, not when it's standing on its end. This is for safety reasons.

Irons | Answered on Apr 29, 2019


Use these magic words on GOOGLE!
"clean the bottom of an iron youtube"... LOTS of ideas there.

Anthony

Irons | Answered on Apr 22, 2019


You asked if there was "some way" and here it is... PROVIDING that your remaining parts DO NOT have any loose wires in the parts left over...

Below see this tubular stuff called "heat shrink"... The more it's heated the more it shrinks down in size... Of course there are 'limits' as to how far it will shrink down so picking the right size is very important.

A common hair dryer will aid you in getting a proper 'shrink' and fit.Because it does shrink, do cut it slightly longer than you actually need... it's easy to trim to size later.

Sooo... as the Heat Shrink heats, it molds itself in place and keeps the iron innards in place too (within the handle and under the shrink)!

No worries about electrical shorts or a bad fit ~ unless you pick on a original heat shrink size that is too large thus causing a loose fit? If you find your heat shrink slipping around "AT ALL"... start over with a slightly smaller size.

Also, as it shrinks it gets slightly thicker around "the shrink cylinder outer walls" thus assuring a lasting snug fit! This also provides a slight measure of protection if the iron is dropped on the shrink protected area.

Of course your iron will continue to transfer heat beyond it's "new-formed body" and your flat iron remains quite useful without worries of rubber or particles imparted to your hair!

Here is what the Heat Shrink looks like... Home Depot may have just the size you need... I suspect it may be a $3 fix!


heat shrink-qtgiynrx5wv4xzkcjqtpk0ew-3-0.jpg
Anthony!

Irons | Answered on Apr 22, 2019


sorry but we do not have them try the place you bought them from

Irons | Answered on Apr 19, 2019


TIME TO BIN IT AND REPLACE WITH NEW ONE

Irons | Answered on Apr 13, 2019


unplu it turn it completely off push switch over do not force it. Plug it back in and see what happens

Irons | Answered on Apr 07, 2019


It depends on what type of iron you have. Newer models have a light to tell you that you are at the temperature you selected. Older ones you try to iron and if it does not work you wait a little longer. Some puts a drop of water on the iron to see hot hot it is.

Irons | Answered on Mar 28, 2019


For more info about Iron keeps blowing trip when turned on:


Dial 1 844 441 2440 for free Garmin map update technical support

Irons | Answered on Mar 25, 2019

Not finding what you are looking for?
Andis Logo

7 questions posted

Ask a Question

Usually answered in minutes!

Top Andis Irons Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

Brad Brown

Level 3 Expert

18157 Answers

Are you an Andis Iron Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...