Andis Irons - Answered Questions & Fixed Issues

The plug is probably not connected to the power cable. Could also be a bad cable or the connection to the clipper.

Andis Fade... | Answered on Jun 18, 2016 | 251 views

If the clippers stopped cutting, they are probably clogged with hair on the inside of the clippers. I had two pairs of clippers where this happened. I took them to be serviced at a beauty supply store and they cleaned the hair from the inside of both pairs of clippers for me and they now work just fine.

Andis SuperLiner... | Answered on Jul 29, 2014 | 250 views

No, the P-Touch is a heat sensitive tape media printer. You can't run cloth through it. Google 'embroidered name tags'. Then you can use iron on tape to glue them down.

Irons | Answered on Jan 11, 2020 | 18 views

Your iron may be indicating a defect that can't be repaired.

Irons | Answered on Dec 16, 2019 | 26 views

High iron content certainly won't do your iron any good. In some cases, only distilled water can be used.

Irons | Answered on Dec 03, 2019 | 33 views

A power surge caused by plugging it in burned out the "dial".

Irons | Answered on Oct 29, 2019 | 47 views

Failure of the heating element or control circuitry

Irons | Answered on Oct 15, 2019 | 57 views

Home Touch might have one.

Irons | Answered on Sep 27, 2019 | 77 views

Heating element or control circuit failure

Irons | Answered on Oct 07, 2019 | 95 views

Use a steam iron or coffee machine descaler powder or liquid.

Irons | Answered on Sep 19, 2019 | 97 views

it could be a bad connection, a bad switch or a bad heating element. It must be disassembled to determine what the problem is. You might look up your model on a parts site and see if they have a breakdown picture. If they do not and do not sell parts, you have your answer. They are considered throw aways.

Irons | Answered on Sep 14, 2019 | 78 views

sometimes the bottom plate can be cleaned. they make polish for that. Normally, it isn't replaceable. The iron will have to come apart to replace the wire. I would not use it until you do as the loose wire might contact the case and then what would you do. Light up?

Irons | Answered on Sep 14, 2019 | 85 views


Irons | Answered on Sep 14, 2019 | 68 views

When cords won't retract, it's usually because they were pulled out too far, ie: past the red line on the cord.
Retractable cords have a limit to how far they can be pulled out in order for the spring to be able to "rewind" them back.
On products with retractable cords, they have a red line near the base of the cord to warn you to stop.

Irons | Answered on Sep 14, 2019 | 55 views

Possibly, but not from fixya

Irons | Answered on Aug 26, 2019 | 55 views

This is not possible easily. You may have to make it with a piece of nylon. A lath mechanic can do it.

Irons | Answered on Aug 21, 2019 | 59 views

Not finding what you are looking for?
Andis Logo

Ask a Question

Usually answered in minutes!

Top Andis Irons Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers


Level 3 Expert

85222 Answers

Brad Brown

Level 3 Expert

18157 Answers

Are you an Andis Iron Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides