Garden - Answered Questions & Fixed Issues


Secondary winding (spark plug wire) to fame 2k to 8k ohms. If infinity (open), then look for break in wire or boot, else internal secondary winding has failed.

This an ignition module so primary winding is not accessible. Check ignition kill wire. Disconnect kill wire at module and measure continuity of kill wire to engine frame. With Run/Stop switch in STOP position it should read zero ohms (a short). In RUN position it should read infinite ohms (open).

Echo Garden | Answered 18 hours ago | 13 views


SAE 10w30 HD

Honda Garden | Answered Yesterday | 40 views


dont even mess with it. take it back and get another one or your money back...next time buy an ariens

Troy Garden | Answered Yesterday | 16 views


???????????????????????????? YOUR DESCRIPTION BAFFLES ME

Garden | Answered 2 days ago | 16 views


Make sure you are using new gas, check the spark as often the induction coil goes bad and needs replacing.

Garden | Answered 2 days ago | 13 views


https://www.bobcatmanualonline.com/downloads/john-deere-chainsaws-cs36-cs40-cs46-cs52-cs56-cs62-cs71-cs81-service-repair-manual

https://www.green-parts-direct.com/john-deere-parts-diagrams/john-deere-cs36-cs36le-cs40-cs40le-cs46-cs52-cs56-cs62-cs71-cs81-chain-saws-pc2847-carburetor-air-filter-cs46/AD-4275-34517-432112

John Deere... | Answered 2 days ago | 19 views


Make sure both the idlers and tensioner pulleys remain aligned, i.e. pulley bearings and tensioner arm aren't wore out.

Possibly one of the transaxle is moving out of place. Check mounting.

You might try raising both rear wheels of the ground and then see if belt throws.

Husqvarna Garden | Answered 3 days ago | 16 views


try a small engine dealer near you

Poulan Garden | Answered on Jan 14, 2020 | 19 views


www.jackssmallengines.com > equipment > list > Exact-Replacement-...

Tiller Exact Replacement Belts - Jacks Small Engines

Type: Raw edge. Width: 1/2" Length: 22" Application: Drive Equipment Type: Tiller Available only as a set from Troy Bilt Requires 2 belts for Troy Bilt GW-1128. www.amazon.ca > Replaces-Craftsman-Poulan-Wizard-132801

1/2 X 52" Belt Replaces Craftsman, Poulan, Yard Man, Wizard ...

This is a general purpose Rotary 1/2 X 52" belt that fits and performs well replacing the 132801 tiller tine drive belt. Part 132801 was used on several brand of tillers made by AYP including: Craftsman, Poulan, Husqvarna, Wizard, Yard Pro, Roper, and more.

Garden | Answered on Jan 14, 2020 | 16 views


Link to some troubleshooting ideas
Like wire connectors are not firmly connected, carry to much load, low battery the link is below
https://www.kidswheels.com/ride-on-toy-troubleshooting-page

https://www.youtube.com/watch?v=EA-XkdxzsGI

Light Garden | Answered on Jan 14, 2020 | 21 views


http://www.tractordata.com/articles/technical/serialnumbers.html

http://www.tractordata.com/farm-tractors/004/0/3/4033-ford-tw-5.html
TW-5 Serial Numbers: Location: Under forward right grill panel 1983: C694500
1984: C707400
1985: C732600
1986: A915854
1987: A917560
1988: A919438
1989: A922535
1990: A925099
Apparently 1986 or 1987 according to the link above.

Ford Garden | Answered on Jan 14, 2020 | 25 views


The ignition module is underneath the blower housing recoil starter. Remove whatever you find necessary to get to the blower housing.

Air gap is 0.016 to 0.020 and mounting bolt torque is 80 - 100 lbin. Do NOT over tighten as threads in block easily strip.

See following for more detail.
https://www.mymowerparts.com/pdf/MTD-Service-Repair-Manuals/MTD-Big-Bore-Engines-78-277cc-83-357cc-90-420cc-Repair-Manual.pdf

Garden | Answered on Jan 14, 2020 | 13 views


NO QUESTION

Snapper Garden | Answered on Jan 14, 2020 | 14 views


Chec utube or buya clymer manual ...gottools

Stihl Garden | Answered on Jan 13, 2020 | 18 views


Your description suggests a part blockage or restriction in the fuel line or perhaps the fuel tank breather isn't allowing air into the tank causing a depression...

Garden | Answered on Jan 13, 2020 | 20 views


Lower inside of each brake drum housing is a slot for adjusting. Typical brake drum pad adjustment wheel is behind the slot.

Suggest you remove wheel and brake drum to inspect pads. Typically what happens is axle seal leaks trans oil and brakes slip.

Ford Garden | Answered on Jan 12, 2020 | 13 views

Not finding what you are looking for?
Garden Logo

Ask a Question

Usually answered in minutes!

Top Garden Experts

roeb

Level 3 Expert

819 Answers

john h

Level 3 Expert

22486 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...