Electrolux Refrigerators - Recent Questions, Troubleshooting & Support

We do not have any manuals.
Try google for your answer.

Electrolux... | Answered on Jan 04, 2020

The door alarm goes off when the door is shut. Reset the alarm and it will repeat in five minutes. The door seal looks fine, the latch on the main body which I assume detects the door is closed has no effect. I powered down the unit with no effect other than the LEDs don't come on now.

Electrolux... | Answered on Aug 22, 2019

Did you also clean the filter screen at the input to the water inlet valve? Just a thought, did you remember to fully turn on the water again after valve replacement? It also might be worth disconnecting the line and make sure pressurized water is coming out (with the cutoff turned back on, that is).

Electrolux... | Answered on Jun 15, 2019

Ask a parts supplier whether the seal is listed as a separate part.

Electrolux... | Answered on May 03, 2019


make model manual

They are all online. Only those with electronic displays have some sort of reset. Normally, disconnecting the power for a few minutes is an acceptable reset.


Electrolux... | Answered on Mar 14, 2019

Is the auger stuck? Are you able to take out the ice bin if so take it out and see if you can spin the auger maybe even empty out all the ice and put bin back in and see it you can hear it spinning. If not it may be a board or motor issue.

Electrolux... | Answered on Mar 06, 2019

Most likely it has a computer board and no mechanical timer.

Electrolux... | Answered on Feb 27, 2019

Maximum efficiency is achieved when there is the greatest difference between high side and low side provided the low side stays under 30 psi or so. The low side pressures must stay low enough to cause the refrigerant to change states in the evaporator. If you see frost on the compressor suction line, there's too much refrigerant, and you'll overload the compressor. The correct approach, if you have the equipment and it sounds like you must have a gauge set but you need recovery to do this right, is to evacuate the sealed system, (a tight system will hold a vacuum overnight, but an hour is a good test if you suspect any leaks) and refill with the exact amount of refrigerant (by weight) as indicated on the ID tag.. Any system that will not perform when filled to that specification has either a bad valve in the compressor, or a restriction caused by contamination. Contamination is usually from moisture (humidity) introduced into the system by improper servicing, but is usually relieved if the system is under vacuum long enough to boil out the moisture. If the compressor is the culprit, it's usually game-over.

Electrolux... | Answered on Feb 02, 2019

Not finding what you are looking for?
Electrolux Logo

1,344 questions posted

Ask a Question

Usually answered in minutes!

Top Electrolux Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4656 Answers


Level 3 Expert

85223 Answers

Felizardo Erilla
Felizardo Erilla

Level 2 Expert

241 Answers

Are you an Electrolux Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides