Fedders Dehumidifiers - Page 4 - Recent Questions, Troubleshooting & Support
The float switch where it pivots wore out i would
I think what you're looking for is the bucket or tank assembly that has the float valve in it, rather than the tray. In any event, there are not many parts still available for this unit, as it has been discontinued by Fedders. However, they did make the identical unit for Maytag & Whirlpool and you may be able to find interchangeable parts from them.
In the meantime, here is a link to some Fedder's parts that are still available for your model.Which may be helpful in cross referencing the Maytag & Whirlpool models.http://www.appliancefactoryparts.com/dehumidifiers/fedders/a7dh45b2a-a.html
Sears Parts Central may be another good source.
Hope this information has helped steer you in the right direction.
on Aug 27, 2012
The float is broken
If all you need is the Styrofoam float, you're in business, If it's the entire float arm you're not so lucky.
See ref numbers
on Sep 20, 2011
My dehumidifier freezes up.
I don't think there is anything wrong with your machine ... What I think you should do is get another fan and blow air onto the rear of your dehumidifier. I also think you should select a higher setting until you get some of the water out of the air. When you get down to 80% for example (evidenced by the machins turning off - set it then to 70% and so on until you arrive at the moisture content you desire (50% is usually considered perfect.) You might also consider adding another machine to help the first, same setup with a fan blowing on it.
This is what I did when my dehumidifier did the same thing yours is doing.
Thanks for your quesiton @ FixYa.com
on Sep 12, 2011
How do I switch the
Disconnect the hose and replace the drain cap, that was removed to connect the hose.
Hope this helped you and thanks for choosing FixYa.
on Sep 08, 2011
Not finding what you are looking for?