Linksys CIT - Recent Questions, Troubleshooting & Support
"please upgrade your operating system"
I had the same problem. Bought a CIT300 off ebay. Cisco/Linksys no longer provide drivers for this device. I'm running Windows 7. I downloaded a driver from Softpedia, says it is from Microsoft dated 7/12/13 version 6.1.7601.18208. It solved my problems. Hope this helps.
on Jan 21, 2015
use you Internet Explorer and browse into the quad that is marked on the bottom of the phone unit which should be something like 192.168.1.40 or something like that and go into the config and you should find the number there but it might be somewhere else as I have not had this type of phone I don't know where else to look.
on Aug 31, 2014
The problem has been solved .. . thank you . The hand set had in fact been somehow un registered from the 'Sender ' . I looked up how to register the hand set ( no way would I have thought of holding down the page button on sender for a few seconds , actually until it starts to flash and then you have (via the menu ) to get the hand set into register mode ( you will need your PIN no. if you changed it from factory default ! If you haven't changed it then factory default is ' 0000' ) . . . punch that in to the hand set and then bingo , they are in touch again . . . .
It took HOURS to get it right . . . I tried removing CIT200 and Skype and then reload into computer . . . and I'm not sure now if I have the upgrade or not of CIT200 . . . this morning had the on going problem of phone saying ' unavailable ' and the only way out of this is to reboot my computer . . . that mostly works ! Apart from these BIG niggles the system is clear and good when all configured . . . NOT found the answer to the Niggles yet ! . . . . . ( Why no hard copy of the user manual . . . ridiculous!)
on Jan 15, 2014
Not finding what you are looking for?