Maytag Washing Machines - Answered Questions & Fixed Issues


If there is a LOCK button hold it down for 15 seconds

Maytag Washing... | Answered Yesterday | 33 views


POSSIBLY THE DOOR SWITCH SHIFTED

Maytag Washing... | Answered on Jan 14, 2020 | 17 views


Most likely a bad main board. If you have the model info, i could possible over more details, thanks

Maytag Washing... | Answered on Jan 12, 2020 | 20 views


call maytag repairman

Maytag Washing... | Answered on Jan 08, 2020 | 33 views


F04 E04 means low power voltage to dryer - check both sides of AC receptacle for 110 to 120VAC on each side to ground - check breaker panel for tripped or bad 220VAC breaker. Only one side may be suppling voltage to dryer.

Maytag Washing... | Answered on Jan 08, 2020 | 22 views


May be a water pressure sensor problem.
This tells it when the tub is full.
start with this video
https://www.youtube.com/watch?v=2pIVkAxWSXg

Maytag EPIC... | Answered on Jan 03, 2020 | 2,248 views


Well I just changed the capacitor on my washer. It would fill with water and stop. My first thought was lid switch it checked out good. Next timer but usually if you switch to another type wash cycle it did not work so I thought timer must be good. I tried to get it to pump out so I pulled pump off shaft and it turned free( I have direct drive to pump no belt) Two metal band clip on to hold pump and motor shaft turned free. I then checked capacitor it would not charge and was not storing charge. The capacitor can shock you very bad do not touch metal connectors till you discharge stored voltage. I dropped water level by just putting end of drain hose in five gallon bucket I had to dump several buckets. I ended emptying by scoping water out with big plastic cup into bucket. I have no bottom on my Maytag so I just leaned it against the wall to get to pump and capacitor. A couple times when I tried to start with washer full of water, I would hear a buzz sound at bottom but not every time. Washer has been working great for 2 weeks now. Make sure to unplug washer before working on it.

Maytag Washing... | Answered on Jan 01, 2020 | 42 views


When door locks like that next time. If you remove the top of the machine. Reach down inside on left side. There is a small wire cable that you pull up on. Will manually unlock the door. Then plug power cord in to wall. Power it on let it go through reset cycle and it will work properly again. However if you can't reach the latch through the top. Tilt washer forward and reach up from the bottom. If you get an F1 code it's low water pressure.

Maytag Neptune... | Answered on Dec 31, 2019 | 891 views


Needs further investigation. It seems to be your control board has an issue.

Maytag Washing... | Answered on Dec 26, 2019 | 39 views


Don't try to fix it yourself it could cost you more in the long run but if the shaft isn't turning the propeller more than likely there is something in the pump stopping it like a small sock for example call a repair tech worse case is u need a new pump

Maytag Washing... | Answered on Dec 26, 2019 | 54 views


U should just use your normal setting wash in warm water rinse with cold I've got 30 yrs appliance repair exsperiance washers were my specialty

Maytag Washing... | Answered on Dec 20, 2019 | 40 views


Contact a Maytag dealer

Maytag Washing... | Answered on Dec 15, 2019 | 36 views


YOU CALL A MAYTAG REPAIR SERVICE TECH .

Maytag Washing... | Answered on Dec 09, 2019 | 37 views


Hi!!
Click on the following link for a diag. of the control panel. to get access to the back of the Control Board http://www.searspartsdirect.com/partsdirect/partsdirect/showSubComp.pd?imageUrl=http://c.searspartsdirect.com/lis_png/PLDM/W0901032-00003.png
check that wiring harness (#8) connections to the Electronic Control Board are tight and the wiring is not broken, burned or damaged. Disconnect the Unit and feel the wire harness (#8) for any small bumps or deformities, repair as needed.

Good Luck! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa!!

Maytag MHWZ600TB... | Answered on Dec 08, 2019 | 1,512 views


FIXYA HAS NO IDEA BUT MAYTAG IS NOT OUT OF BUSINESS CONTACT THEM WWW.MAYTAG.COM

Maytag Washing... | Answered on Dec 05, 2019 | 34 views

Not finding what you are looking for?
Maytag Logo

Family Lines

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

jimorris77

Level 3 Expert

411 Answers

Sheldon Dedek

Level 3 Expert

909 Answers

Bill Long

Level 3 Expert

606 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...