Westinghouse Washing Machines - Recent Questions, Troubleshooting & Support


It does sound as if the machine is going out of balance. Perhaps you load too much in or there is not enough water entering the machine to spread the load.

Westinghouse... | Answered on Nov 20, 2018


indicates that the tub support air dampeners are failed allowing the tub not to be level
normally there is a small amount of water in the tub as the spin starts to allow the cloths to move around for balance but when the air dampeners break there is no initial control for the balance so the tub gets all out of wack

Westinghouse... | Answered on Apr 16, 2018


I found this

The 5 beeps indicates that the lid switch isn't being sensed*

The out of balance switch is separate to the lid switch on these machines. The 3 water level light does indicate the Out of balance switch as faulty, if it is accompanied by 15 beeps. 5 beeps means the lid switch = LD.

This is what I want you to do.

Open the lid up. Study the left and right hand sides of the lid while it is open. You should see a little bulge in the plastic on one side. From memory it is the left hand side when standing in front of the machine...

This is the magnet in the lid, when the lid is closed, it lines up with a sensor on the underside of the top hob of the machine.

If you stick your hand up underneath the top of the machine in this location, above the bowl, you should be able to feel the sensor and the wires going to it..

Sometimes these sensors fall out of where they clip to on the underside of the top of the machine. Feel around and see if it is hanging down okay...

If you cant find it, dig the plastic caps out from the top front of the machine where the lid closes against, undo the 2 screws, undo the screws across the back of the top of the machine and raise the entire top by gently* swinging the top up and back against the wall and then you will see what I am talking about.

Apart from falling out of where they clip into under the hob, the sensor can corrode away and fail. If yours looks corroded or bulging, it will need replacing..

This is where the problem is I'm thinking, especially if you have already replaced the out of balance switch and of course, the 5 beeps.

Try the above suggested and let me know how you go okay,,,

Any further questions, even after rating, just ask, I'm happy to answer them.

I can link you to a cheap parts supplier who ships nationwide fast and cheap if required..no problems at all.


Westinghouse washing macjhine Lt608s goto start beeps water

Westinghouse... | Answered on Feb 10, 2018

Not finding what you are looking for?
Westinghouse Logo

365 questions posted

Ask a Question

Usually answered in minutes!

Top Westinghouse Washing Machines Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Mike

Level 3 Expert

4368 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

Are you a Westinghouse Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...