Press enter to search.
The quicker fucker upper.
Dan Hooper posted an answer for this Cars & Trucks:
"Should be bolted to the top of the block and points into the bell housing."
"Yes and no. The 2wd trans will physically bolt up to the engine, but you will need a..."
Dan Hooper posted an answer for this Acura Cars & Trucks:
"I would check for worn motor mounts and CV joints on the front axles. These would be the..."
"Your best bet is to tap in a mechanical gauge to verify that you do have proper oil..."
"Could be a number of things, but I would start with the throttle position sensor."
"Stuck Thermostat, Cooling fan not operating, bad cap? Could be several things including a..."
Dan Hooper posted an answer for this Hummer Cars & Trucks:
"Try lubricating the tracks on each side of the window, if it is trying to go up, this..."
"The factory does not have a valet button. If your car has had an alarm added, the shop..."
Dan Hooper posted an answer for this Pontiac Cars & Trucks:
Dan Hooper posted an answer for this Mazda Cars & Trucks:
"Sounds like you either have air in the clutch system or your clutch master cylinder or..."
Dan Hooper posted an answer for this Mitsubishi Cars & Trucks:
"Possibly starter, or could be a bad connection, bad ignition switch, clutch safety switch?..."
"Easiest thing to do is remove the fuel line and cycle the pump. You will be able to tell..."
Dan Hooper posted an answer for this Nissan Cars & Trucks:
"Can you hear the motor run when you turn the switch on? If so, I would say you need to..."
Dan Hooper posted an answer for this Chrysler Cars & Trucks:
"How hot did it get? If it was hot enough to blow a head gasket or crack a head, there is a..."
Dan Hooper posted an answer for this Volkswagen Cars & Trucks:
"Is your ECU getting a signal from the crank and cam sensors?"
"There is a shifter interlock that will not allow it to move unless the vehicle is on and..."
"Yes, it should. Your voltage regulator is integrated inside of the ECU. Unfortunately,..."
"If I remember correctly, those have to be set by the dealer with a scan tool."
"Sounds like you need a transmission shop. I'd bet the shift solenoid harness is bad."
Dan Hooper posted an answer for this Buick Cars & Trucks:
"Remove the negative battery cable for 10-15 seconds."
Dan Hooper posted an answer for this Dodge Cars & Trucks:
"You have more than one, they are all located in the tailpipe after the exhaust manifold."
Dan Hooper posted an answer for this Geo Cars & Trucks:
"Should unless one has been changed."
Dan Hooper posted an answer for this Toyota Cars & Trucks:
"Since there is very little fluid movement when you press in on the master cylinder and the..."
"Inside of the fuel tank. Your truck has a fuel sending module that contains the pump,..."
Dan Hooper posted an answer for this Refrigerators:
"I believe I would be taking it back for either a refund or replacement."
"Check your PCV valve and see if it is plugged up."
"Possibly a bad temperature sensor not putting the computer into phase lock loop?"
"If you go to www.car-part.com, they have a built in Hollander interchange. What ever comes..."
"Without knowing what it is you are working on, it is impossible for us to help, but your..."
"I usually just do one ugga-dugga, but I believe if you look at the spec it is about 25..."
Load more activity...
245,614 people helped
View all achievements